User guide

Back to Contents Page
Using the Module Bay
DellPrecision™M60SeriesMobileWorkstationUser'sGuide
About the Module Bay
Checking the Charge on the Second Battery
Removing and Installing Devices While the Computer Is Turned Off
Removing and Installing Devices While the Computer Is Running
Using the CD or DVD Tray
About the Module Bay
You can install devices such as a floppy drive, CD drive, CD-RW drive, DVD drive, CD-RW/DVDdrive,DVD+RW,DellTravelLite™module,secondbattery,or
second hard drive in the module bay.

YourDell™computershipswithanopticaldriveinstalledinthemodulebay.However,thedevicescrewisnotinstalledintheopticaldrivebutpackaged
separately. When you install your device in the module bay, you can install the device screw.

Checking the Charge on the Second Battery
Before you install a second battery, press the status button on the battery charge gauge to illuminate the charge-level lights. Each light represents
approximately 20 percent of the total battery charge. For example, if the battery has 80 percent of its charge remaining, four of the lights are on. If no lights
appear, the battery has no charge.


Removing and Installing Devices While the Computer Is Turned Off

Your computer ships with an optical drive installed in the module bay. However, the device screw is not installed in the optical drive but packaged separately.
When you install your device in the module bay, you can install the device screw.

NOTE: All devices that you install in the module bay, except a second battery, can also be installed in the Dell D/Bay.
NOTE: You do not need to install the device screw unless you want to secure the module inside the computer for security purposes.
1
status button on the
charge gauge
2
second battery (top)
NOTE: If the device screw is not installed, you can remove and install devices while the computer is running and connected to a docking device
(docked).