Setup Guide

12 Rack Installation Guide

Installing the Mounting Rails in the Rack

Installing RapidRails Mounting Rails

NOTE: Ensure that the rotating mounting brackets on the slide assemblies are in the RapidRail configuration.

See Figure 1-5.

At the front of the rack cabinet, position one of the mounting rails so that its mounting-bracket flange

fits between the marks or tape you placed (or numbered locations) on the vertical rails in "Marking the

Rack" on page 9 (see Figure 1-5).

The top mounting hook on the front mounting-bracket flange should enter the top hole between

the marks you made on the vertical rails.

Figure 1-5. Installing RapidRails Mounting Rails

1 mounting hooks (4) 2 push buttons (2) 3 mounting rails (2)

front of rack