Owners Manual

Error Message Description
memory modules and, if necessary,
replace them.
Diskette drive 0 seek failure A cable may be loose or the computer
configuration information may not match
the hardware configuration.
Diskette read failure The floppy disk may be defective or a
cable may be loose. If the drive access
light turns on, try a different disk.
Diskette subsystem reset failed The floppy drive controller may be faulty.
Drive not ready No floppy disk is in the drive. Put a floppy
disk in the drive.
Diskette write protected The floppy disk is write-protected. Slide
the write-protect notch to the open
position.
Gate A20 failure One or more memory modules may be
faulty or improperly seated. Reinstall the
memory modules and, if necessary,
replace them.
General failure The operating system is unable to carry
out the command. This message is usually
followed by specific information—for
example, Printer out of paper. Take the
appropriate action to resolve the problem.
Hard-disk drive configuration error The hard drive failed initialization.
Hard-disk drive controller failure The hard drive failed initialization.
Hard-disk drive failure The hard drive failed initialization.
Hard-disk drive read failure The hard drive failed initialization.
Invalid configuration information-please
run SETUP program
The computer configuration information
does not match the hardware
configuration.
Invalid Memory configuration, please
populate DIMM1
DIMM1 slot does not recognize a memory
module. The module should be re-seated
or installed.
Keyboard failure A cable or connector may be loose, or the
keyboard or keyboard/mouse controller
may be faulty.
77