Owner's manual

www.dell.com | support.dell.com
16 Using Your Projector
Using the Control Panel
1 Power Turn the projector on and off. For more information,
see "Turning Your Projector On" on page 11 and
"Turning Your Projector Off" on page 11.
2 Source Press to toggle through Analog RGB, Composite,
Component-i, S-video, and Analog YPbPr sources when
multiple sources are connected to the projector.
3 Four Directional
Keys
The four directional keys can be used to
toggle through the tabs in the OSD.
4 TEMP warning light
• A solid orange TEMP light indicates that the projector
has overheated. The display automatically shuts
down. Turn the display on again after the projector
cools down. If the problem persists, contact Dell.
• A blinking orange Temp light indicates that a
projector fan has failed and the projector
automatically shuts down. If this problem persists,
contact Dell.
5 LAMP warning light If the Lamp light is solid orange, replace the lamp.
6 Keystone adjustment If your image is not perpendicular to the screen, then it
does not appear square. Press to adjust image distortion
caused by tilting the projector. (±16 degrees)
7 Resync Press to synchronize the projector to the input source.
Resync does not operate if the on-screen display (OSD)
is displayed.
1
2
3
4
5
6
7
8