Service Manual
Table Of Contents
- Precision 3660 Tower Service Manual
- Contents
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Precision 3660 Tower
- Side cover
- Front bezel
- 3.5 in. hard-drive assembly
- Removing the 3.5-inch hard-disk drive assembly (Bay-1)
- Removing the 3.5-inch hard-disk drive assembly (Bay-2)
- Removing the 3.5-inch hard-disk drive bracket
- Installing the 3.5-inch hard-disk drive bracket
- Installing the 3.5-inch hard-disk drive assembly (Bay-2)
- Installing the 3.5-inch hard-disk drive assembly (Bay-1)
- Solid-state drive
- WLAN card
- WLAN antenna
- Coin-cell battery
- Memory module
- GPU end holder
- Expansion card
- Power-supply unit
- Processor fan and heat-sink assembly
- Liquid cooler
- Processor
- Chassis fan
- Power button
- Intrusion switch
- Intrusion speaker
- System board
- Software
- System setup
- Troubleshooting
- Getting help and contacting Dell
Steps
1. Align the notch on the memory module with the tab on the memory-module slot.
2. Slide the memory module firmly into the slot at an angle and press the memory module down until it clicks into place.
NOTE: If you do not hear the click, remove the memory module and reinstall it.
Next steps
1. Install the side cover.
2. Follow the procedure in after working inside your computer.
GPU end holder
Removing GPU end holder
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
About this task
The following images indicate the location of the GPU end holder and provide a visual representation of the removal procedure.
Removing and installing components
33