Service Manual
Table Of Contents
- Precision 3660 Tower Service Manual
- Contents
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Precision 3660 Tower
- Side cover
- Front bezel
- 3.5 in. hard-drive assembly
- Removing the 3.5-inch hard-disk drive assembly (Bay-1)
- Removing the 3.5-inch hard-disk drive assembly (Bay-2)
- Removing the 3.5-inch hard-disk drive bracket
- Installing the 3.5-inch hard-disk drive bracket
- Installing the 3.5-inch hard-disk drive assembly (Bay-2)
- Installing the 3.5-inch hard-disk drive assembly (Bay-1)
- Solid-state drive
- WLAN card
- WLAN antenna
- Coin-cell battery
- Memory module
- GPU end holder
- Expansion card
- Power-supply unit
- Processor fan and heat-sink assembly
- Liquid cooler
- Processor
- Chassis fan
- Power button
- Intrusion switch
- Intrusion speaker
- System board
- Software
- System setup
- Troubleshooting
- Getting help and contacting Dell
Steps
1. Align the graphics card with the PCI-Express card connector on the system board.
2. Using the alignment post, connect the graphics card in the connector and press down firmly. Ensure that the card is firmly
seated.
3. Lift the pull tab to close the PCIe door.
Next steps
1. Install the side cover.
2. Follow the procedure in after working inside your computer.
Removing the powered GPU
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
3. Remove the GPU end holder.
Removing and installing components
37