Install Guide

2–Installing QConvergeConsole GUI
Installing QConvergeConsole GUI
Doc. No. TD-000966 Rev. 1
January 21, 2021 Page 18 Copyright © 2021 Marvell
Installing QConvergeConsole GUI in a Solaris Environment
You can graphically install QConvergeConsole GUI on a Solaris host by running a
Virtual Network Computing (VNC) program on a remote host. The TightVNC
Viewer, a VNC program, can remotely control QConvergeConsole GUI installation
on a Solaris host.
To install QConvergeConsole GUI in a Solaris environment:
1. Open the appropriate directory containing the installer file:
 QConvergeConsole_Installer_Solaris_SPARC_<version>.bin
 QConveregConsole_Installer_Solaris_x86_<version>.bin
2. From the terminal window, verify that the installer file has permission to
execute by issuing the ls -lt command at the prompt.
3. To install QConvergeConsole GUI, issue the appropriate command on the
console:
 For SPARC:
sh QConvergeConsole_Installer_Solaris_SPARC_<version>.bin
 For x86:
sh QConvergeConsole_Installer_Solaris_x86_<version>.bin
The InstallAnywhere GUI utility prepares to install QConvergeConsole GUI
and opens the installation Introduction dialog box.
4. Click Next.
5. In the Tomcat Port Number Setup dialog box, type a valid port number in the
range 1025–65536, or accept the default port number, 8080. Then click
Next to continue.
6. In the next dialog box, select Yes if you want a localhost-only installation. If
you do not want a localhost-only installation, select No.
NOTE
FastLinQ Adapters (3400/8400/41000/45000 Series) currently do not
support Solaris.
NOTE
The localhost-only option locally installs QConvergeConsole GUI so
that you must run it locally (remote connection is not possible). To
disable the option, you must uninstall QCC GUI and then re-install it,
selecting No in this step.