Users Guide

9–Windows Driver Software
Installing the Driver Software
97 BC0054508-00 M
To install the Microsoft iSCSI Software Initiator for iSCSI Crash Dump:
If supported and if you will use the Marvell iSCSI Crash Dump utility, it is important
to follow the installation sequence:
1. Run the installer.
2. Install Microsoft iSCSI Software Initiator along with the patch
(MS KB939875).
Using Silent Installation
To perform a silent install from within the installer source folder:
Issue the following command:
setup /s /v/qn
To perform a silent upgrade from within the installer source folder:
Issue the following command:
setup /s /v/qn
To perform a silent reinstall of the same installer:
Issue the following command:
setup /s /v"/qn REINSTALL=ALL"
NOTE
If you are upgrading the device drivers from the installer, re-enable iSCSI
Crash Dump from the Advanced section of the QCC GUI Configuration
page.
NOTE
 All commands are case sensitive.
 For detailed instructions and information about unattended installs, refer to
the
silent.txt file in the Driver_Management_Apps_Installer
folder.
NOTE
The REINSTALL switch should only be used if the same installer is already
installed on the system. If upgrading an earlier version of the installer, use
setup /s /v/qn as listed in the preceding.