Users Guide

11–Marvell Teaming Services
Event Log Messages
199 BC0054508-00 M
Base Driver (Physical Adapter or Miniport)
The base driver is identified by source L2ND. Tab l e 11 - 8 lists the event log
messages supported by the base driver, explains the cause for the message, and
provides the recommended action.
NOTE
In Table 11-8, message numbers 1 through 17 apply to both NDIS 5.x and
NDIS 6.x drivers, message numbers 18 through 23 apply only to the
NDIS 6.x driver.
Table 11-8. Base Driver Event Log Messages
Message
Number
Severity Message Cause Corrective Action
1 Error Failed to allocate
memory for the
device block. Check
system memory
resource usage.
The driver cannot allo-
cate memory from the
operating system.
Close running applica-
tions to free memory.
2 Error Failed to allocate
map registers.
The driver cannot allo-
cate map registers from
the operating system.
Unload other drivers
that may allocate map
registers.
3 Error Failed to access
configuration infor-
mation. Reinstall the
network driver.
The driver cannot
access PCI configura-
tion space registers on
the adapter.
For add-in adapters:
reseat the adapter in
the slot, move the
adapter to another PCI
slot, or replace the
adapter.
4 Warning The network link is
down. Check to
make sure the net-
work cable is prop-
erly connected.
The adapter has lost its
connection with its link
partner.
Check that the network
cable is connected, ver-
ify that the network
cable is the right type,
and verify that the link
partner (for example,
switch or hub) is work-
ing correctly.
5 Informational The network link is
up.
The adapter has estab-
lished a link.
No action is required.