Users Guide

6–Boot from SAN Configuration
iSCSI Boot from SAN
92 AH0054602-00 M
Configuring the iSCSI Targets
You can set up the iSCSI first target, second target, or both at once.
To set the iSCSI target parameters on Windows:
1. From the Main Configuration page, select iSCSI Configuration, and then
select iSCSI First Target Parameters.
2. On the iSCSI First Target Parameters page, set the Connect option to
Enabled for the iSCSI target.
3. Type values for the following parameters for the iSCSI target, and then
press ENTER:
 IPv4* Address
 TCP Port
 Boot LUN
 iSCSI Name
 CHAP ID
 CHAP Secret
4. If you want to configure a second iSCSI target device, select iSCSI Second
Target Parameters (Figure 6-12 on page 81), and enter the parameter
values as you did in Step 3. This second target is used if the first target
cannot be connected to.Otherwise, proceed to Step 5.
5. In the Warning dialog box, click Yes to save the changes, or follow the OEM
guidelines to save the device-level configuration.
Detecting the iSCSI LUN and Injecting the Marvell Drivers
1. Reboot the system, access the HII, and determine if the iSCSI LUN is
detected. Issue the following UEFI Shell (version 2) script command:
map -r -b
NOTE
For the preceding parameters with an asterisk (*), the label will change
to IPv6 or IPv4 (default) based on IP version set on the iSCSI General
Parameters page, as shown in Figure 6-7 on page 75.