Users Guide

6–Boot from SAN Configuration
FCoE Boot from SAN
117 AH0054602-00 M
4. On the Main Configuration Page, select NIC Configuration (Figure 6-28),
and then press ENTER.
Figure 6-28. System Setup: NIC Configuration
5. On the NIC Configuration page, select Boot Mode, press ENTER, and then
select FCoE as a preferred boot mode.
NOTE
FCoE is not listed as a boot option if the FCoE Mode feature is disabled at
the port level. If the Boot Mode preferred is FCoE, make sure the FCoE
Mode feature is enabled as shown in Figure 6-29. Not all adapter versions
support FCoE.