Users Guide

4–Switch Independent Partitioning
Switch Independent Partitioning Setup and Management Options
159 CU0354602-00 M
Configure Switch Independent Partitioning
You can use the NIC Partition Management tab in the device properties page to
enable Switch Independent Partitioning and configure the 10GbE physical port
into a multifunction storage and networking port.
To set up Switch Independent Partitioning on a QLogic adapter port:
1. Log in to the server that contains installed QLogic adapters.
2. Open the Server Manager and select Diagnostics, then select Device
Manager, and then select Network Adapters.
3. Right-click on the first QLogic 10GbE 2P <model> device and select
Properties from the shortcut menu (see Figure 4-25).
Figure 4-25. Selecting Properties from the Shortcut Menu