Users Guide

5–Boot Configuration
Dell System Setup
189 CU0354602-00 M
iSCSI First Target Parameters
The iSCSI First Target Parameters page (see Figure 5-10) lets you set the
following:
 IP Version: This option indicates whether IPv4 or IPv6 is selected.
 IPv4 Address: If IPv4 is selected, this field let you specify the IPv4 address
of the intended iSCSI boot target.
 IPv6 Address: If IPv4 is selected, this field lets you specify the IPv6 address
of the intended iSCSI boot target.
 Target Port: This field lets you specify the port used by the target. It must be
set to 3260. By default, iSCSI uses port 3260. Do not modify this field unless
it is necessary.
 Boot LUN: This field lets you specify the LUN of the boot device.
 Target Name: This field lets you specify the iSCSI target name of an
intended boot target.
 CHAP ID: This field lets you configure the CHAP name. This field is
dependent upon the CHAP configuration on the iSCSI General Parameters
page.
 CHAP Secret: This field lets you configure the CHAP secret. This field is
dependent upon the CHAP configuration on the iSCSI General Parameters
page.
Figure 5-10. iSCSI First Target Parameters