Users Guide

14–Fibre Channel Over Ethernet
Configuring FCoE
238 BC0054508-00 J
To enable and disable the FCoE-offload instance on Windows using QCC
GUI:
1. Open QCC GUI.
2. In the tree pane on the left, under the port node, select the port’s virtual bus
device instance.
3. In the configuration pane on the right, click the Resource Config tab.
The Resource Config page appears (see Figure 14-39).
Figure 14-39. Resource Config Page
4. Complete the Resource Config page for each selected port as follows:
a. To enable FCoE offload for the port, for the FCoE parameter, select the
Value check box.
b. To disable FCoE offload for the port, for the FCoE parameter, clear the
Value check box.
c. Click the Apply button.
5. (optional) To enable or disable FCoE offload in single function or NPAR
mode on Windows or Linux using QCS CLI, see the User’s Guide, QLogic
Control Suite CLI (part number BC0054511-00). To enable or disable FCoE
offload in single function or NPAR mode on Windows or Linux using the
QCC PowerKit, see the User’s Guide, PowerShell (part
number BC0054518-00). To locate these documents, see “Downloading
Documents” on page xxiii.