Users Guide

16–SR-IOV
Enabling SR-IOV
246 BC0054508-00 J
To enable SR-IOV:
1. Enable the feature on the adapter using either QCC GUI, QCS CLI, Dell
pre-boot UEFI, or pre-boot CCM.
If using Windows QCC GUI:
a. Select the network adapter in the Explorer View pane. Click the
Configuration tab and select SR-IOV Global Enable.
b. In the SR-IOV VFs per PF box, configure the quantity of SR-IOV
virtual functions (VFs) that the adapter can support per physical
function, from 0 to 64 in increments of 8 (default = 16).
c. In the SR-IOV Max Chains per VF box, configure the maximum
quantity of transmit and receive queues (such as receive side scaling
(RSS) queues) that can be used for each virtual function. The
maximum is 16.
If using pre-boot UEFI:
a. During power up, press F2 at the prompt to enter the Dell System
Setup.
b. Select the Device Settings menu.
c. Select the SR-IOV-capable adapter port from the Device Settings
menu.
d. Select the Device Level Configuration Menu on the Main
Configuration Page.
e. In the Virtualization Mode list, select SR-IOV or NPar+SR-IOV (if you
want SR-IOV-over-NPAR mode) control.
f. If in SR-IOV mode (without NPAR mode), select the desired number of
VFs for this port in the Number of VFs Per PF control window.
The 2x1G+2x10G BCM57800 allows up to 64 VFs per 10G port (the
BCM57800's two 1G ports do not support SR-IOV). The 2x10G
BCM57810 allows up to 64 VFs per port. The 4x10G BCM57840
allows up to 32 VFs per port.
g. If in SR-IOV (with NPAR mode), each partition has a separate Number
of VFs Per PF control window. Press ESC to return to the Main
Configuration Page, and then select the NIC Partitioning
Configuration menu (which appears only if NPAR mode is selected in
the Virtualization Mode control). In the NIC Partitioning Configuration
page, select each Partition “N” Configuration menu and set the
Number of VFs per PF control. The total number of VFs assigned per
PF on a single physical port cannot exceed the numbers assigned in
Step f.