Users Guide

5–Fibre Channel Noninteractive Commands
-q (Target Link Speed [iiDMA])
Doc. No. TD-000947 Rev. 1
Janurary 29, 2021 Page 78 Copyright © 2021 Marvell
If both <target id> and <lun id> are omitted, the -pl command lists all
udev names that are currently assigned to all devices attached to a physical port
on the adapter.
To remove a udev persistent device name from a LUN, issue the following command :
qaucli -pr fc -pl <hba instance>|<hba wwpn> --del (<target ID>
<lun ID> <lun name>)...
Where:
To add a udev persistent device name to a LUN, issue the following command :
qaucli -pr fc -pl <hba instance>|<hba wwpn> --set (<target ID>
<lun ID> <lun name>)
-q (Target Link Speed [iiDMA])
To view the link speed of all targets attached to one adapter or all adapters, issue
the -q command as follows:
qaucli -pr fc -q <hba instance>|<hba wwpn>|all [-targets|-t]
Where:
<hba instance> = Adapter number (use the -g command to find)
<hba wwpn> = World wide port name of the adapter
<target id> = Name of the firmware preload table DAT file.
<lun id> = ID of the LUN
<lun name> = Name of the LUN
NOTE
The parameter group <target ID> <lun ID> <lun_name> can be
specified more than once. For example:
...targetID1 lunID1 lun_name1 targetID2 lunID2 lun_name2
NOTE
The -q option is supported only on 4Gb adapters.
<hba instance> = Adapter number (use the -g command to find)
<hba wwpn> = World wide port name of the adapter
all = Reports link speed for all targets on all adapters in the system
-targets or -t = All targets