Users Guide

5–Managing Marvell 578xx and 41000 Series Adapters
Configuring Port Boot Options
Doc. No. TD-000965 Rev. 1
January 21, 2021 Page 101 Copyright © 2021 Marvell
Configuring MBA Boot
To configure the MBA boot:
1. In the QConvergeConsole system tree, select an adapter, and then select
the appropriate port.
2. In the content pane on the right, click Boot Configuration.
3. Click the MBA button.
4. On the MBA Configurations page, complete the following:
a. Select the Option ROM check box to enable the ROM option, or clear
the check box to disable it.
b. Select one of the options for Boot Protocol.
Options for 578xx Series Adapters:
 None
 PXE
 FCoE Boot (if available)
 iSCSI Boot (if available)
Options for 41000 Series Adapters:
 None
 PXE
 iBFT
Note that selecting PXE will disable the iSCSI (offload) Boot. Selecting
iBFT will disable the iSCSI (offload) Boot, and set the iSCSI Boot
Mode to non-offload.
c. Select one of these options for Boot Strap Type:
 Auto
 BBS
 Int 18h
 Int 19h
d. Select the Hide Setup Prompt check box to enable the Hide Setup
Prompt, or clear the check box to disable the prompt for preboot
comprehensive configuration management (CCM) on 578xx Adapters.
e. Select one of the following Setup Key Stroke options for preboot CCM
on 578xxAdapters:
 Ctrl-S
 Ctrl-B
f. Select a value (from 0 to 14) in the Banner Message Timeout box for
preboot CCM on 578xx Adapters.