Users Guide

8–VMware Driver Software
Driver Parameters
Doc No. BC0054508-00 Rev. R
January 21, 2021 Page 73 Copyright © 2021 Marvell
cnic_dump_kwqe_en
The cnic_dump_kwe_en parameter enables and disables single work-queue
element message (kwqe) logging. By default, this parameter is set to
1
(disabled).
qfle3 Driver Parameters
For a list of valid parameters, issue one of the following commands:
# esxcli system module parameters list -m qfle3
# esxcfg-module -i qfle3
To change a parameter, issue one of the following commands:
#esxcli system module parameters set -m qedentv -p Param=Value
#esxcfg-module -s Param=Value qfle3
debug_mask
Set the debug_mask module parameter only for debug purposes, as the
additional logging will flood numerous messages. Marvell does not recommend
setting this parameter for regular driver use.
The valid values for debug_mask are:
0x00000001 /* load and unload */
0x00000002 /* interrupt handling */
0x00000004 /* slowpath handling */
0x00000008 /* stats updates */
0x00000010 /* packet transmit */
0x00000020 /* packet receive */
0x00000040 /* phy/link handling */
0x00000080 /* not used */
0x00000100 /* dumping mbuf info */
0x00000200 /* register access */
0x00000400 /* lro processing */
0x00000800 /* uplink debug */
0x00001000 /* qeueu debug */
0x00002000 /* hw debug */
0x00004000 /* cmp debug */
0x00008000 /* start process debug */
0x00010000 /* debug assert */
0x00020000 /* debug poll */
0x00040000 /* debug TXSG */
0x00080000 /* debug crash */