Users Guide

3–Fibre Channel Configuration
Configuring Target Persistent Binding
44 CU0354604-00 R
Configuring Persistent Binding with QConvergeConsole GUI
To bind target devices attached to an adapter port using QConvergeConsole
GUI:
1. In the system tree, expand a Fibre Channel node.
2. In the system tree for a 2600 Series Adapter, select the physical port
number.
3. Click the Targets tab, and then click the Target Persistent Binding tab.
4. Choose the binding options:
 Select the Bind All check box to bind all the devices listed to adapter
ports.
 Select the Bind check box if you want to configure a specific port and
bind it to the target ID that you have selected from the Target ID list. If
you do not want to configure the port, clear the check box. If you clear
the check box, the corresponding port is unconfigured.
5. To save the configuration changes, click Save.
6. If the Security Check dialog box appears, type the password in the Enter
Password box, and then click OK.
7. The system overwrites any previously saved configuration for the current
adapter and displays a message box. Click OK to close the message box.
For more information, refer to the topic about binding target devices in the
QConvergeConsole Help.
Configuring Persistent Binding with Interactive
QConvergeConsole CLI
To bind a target using interactive QConvergeConsole CLI:
1. On the Fibre Channel Adapter Configuration menu, select Target
Persistent Bindings.
2. On the port menu, select a port and then select Bind Target(s) to bind a
target to a port.
3. Select a target and specify a target ID to open the Target Persistent
Binding – FC Port Configuration menu with options to select more targets,
save changes, or cancel the binding operation.
For more information, refer to the section about Fibre Channel interactive
commands in the User’s Guide—QConvergeConsole CLI (part number
SN0054667-00).