Users Guide

3–Fibre Channel Configuration
Configuring Boot Devices
45 CU0354604-00 R
Configuring Persistent Binding with Noninteractive
QConvergeConsole CLI
To bind a selected target to a specific adapter using the noninteractive mode of
QConvergeConsole CLI, issue the following command:
# qaucli -pr fc -p (<hba instance> | <hba wwpn>) (<target wwnn>
<target wwpn> <target port id> <target id>)
Where:
For more information, refer to the section about Fibre Channel noninteractive
commands in the User’s Guide—QConvergeConsole CLI (part number
SN0054667-00).
Configuring Boot Devices
Use QConvergeConsole or Fast!UTIL to configure boot devices:
 Configuring Boot Devices with QConvergeConsole GUI
 Configuring Boot Devices with Interactive QConvergeConsole CLI
 Configuring Boot Devices with Noninteractive QConvergeConsole CLI
 Configuring Boot Devices with the BIOS
Configuring Boot Devices with QConvergeConsole GUI
For information about configuring boot devices with QConvergeConsole GUI,
refer to the topics about HBA parameters, viewing or modifying port parameters,
and boot device selection in the QConvergeConsole Help.
Configuring Boot Devices with Interactive
QConvergeConsole CLI
On the Fibre Channel Adapter Configuration menu, select Boot Devices
Configuration to open the Boot Device Settings menu with options to view and
configure boot devices.
hba instance = Adapter number (use the -g command to find)
hba wwnn = Worldwide node name of the adapter
hba wwpn = Worldwide port name of the adapter
target wwnn = Worldwide node name of the target
target wwpn = Worldwide port name of the target
target port id = Port ID of the target
target id = ID to which the target is bound