Users Guide

3–Fibre Channel Configuration
Configuring Virtual Ports (NPIV)
46 CU0354604-00 R
For information, refer to the section about the Fibre Channel interactive
commands in the User’s Guide—QConvergeConsole CLI (part number
SN0054667-00).
Configuring Boot Devices with Noninteractive
QConvergeConsole CLI
To set a specific target as the boot device for a specific adapter, issue the
following command:
# qaucli -pr fc -e (<hba instance> | <hba wwpn>) <target wwnn>
<target wwpn> <target id> <lun id>
Where:
For more information, refer to the “Fibre Channel Noninteractive Commands”
section of the User’s Guide—QConvergeConsole CLI (part number
SN0054667-00).
Configuring Boot Devices with the BIOS
For information about boot device configuration with the Fast!UTIL BIOS utility,
refer to “Using Fast!UTIL for Custom Configuration” on page 36 for information.
Configuring Virtual Ports (NPIV)
Use QConvergeConsole to configure virtual ports for N_Port ID virtualization and
quality of service:
 Configuring NPIV with QConvergeConsole GUI
 Configuring NPIV with Interactive QConvergeConsole CLI
 Configuring NPIV with Noninteractive QConvergeConsole CLI
 Configuring NPIV Quality of Service
hba instance = Adapter number (use the -g command to find)
hba wwpn = Worldwide port name of the adapter
target wwnn = Worldwide node name of the target
target wwpn = Worldwide port name of the target
target id = ID to which the target is bound
lun id = ID of the LUN