Service Manual
Table Of Contents
- OptiPlex 5400 Service Manual
- Contents
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of OptiPlex 5400 All-in-One
- Stand
- Cable cover—optional
- Back cover
- Hard drive
- Memory modules
- System-board shield
- Solid-state drive
- Removing the M.2 2230 solid-state drive-slot 1
- Installing the M.2 2230 solid-state drive-slot 1
- Removing the M.2 2280 solid-state drive-slot 1
- Installing the M.2 2280 solid-state drive-slot 1
- Removing the M.2 2230 solid-state drive-slot 2
- Installing the M.2 2230 solid-state drive-slot 2
- Removing the M.2 2280 solid-state drive-slot 2
- Installing the M.2 2280 solid-state drive-slot 2
- System fan
- Coin-cell battery
- Wireless card
- Camera assembly
- Bottom cover
- Power-supply unit
- Power-supply fan
- Heat sink
- Processor
- Rear-I/O bracket
- System board
- Speakers
- Power-button board
- Microphones
- Side I/O-board
- Audio board
- Antenna modules
- Display panel
- Middle frame
- Drivers and downloads
- BIOS setup
- Troubleshooting
- Getting help and contacting Dell
Steps
1. Press and slide the release button up.
2. Hold the button in the release position, and lift the stand upward.
3. Slide the stand downward, to lift the stand off the back cover.
Installing the height adjustable stand
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
NOTE: Follow the same procedure to install the Height Adjustable Stand with Optical Disk Drive.
About this task
The following image provides a visual representation of the height adjustable stand installation procedure.
Removing and installing components
15