Service Manual
Table Of Contents
- OptiPlex 5400 Service Manual
- Contents
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of OptiPlex 5400 All-in-One
- Stand
- Cable cover—optional
- Back cover
- Hard drive
- Memory modules
- System-board shield
- Solid-state drive
- Removing the M.2 2230 solid-state drive-slot 1
- Installing the M.2 2230 solid-state drive-slot 1
- Removing the M.2 2280 solid-state drive-slot 1
- Installing the M.2 2280 solid-state drive-slot 1
- Removing the M.2 2230 solid-state drive-slot 2
- Installing the M.2 2230 solid-state drive-slot 2
- Removing the M.2 2280 solid-state drive-slot 2
- Installing the M.2 2280 solid-state drive-slot 2
- System fan
- Coin-cell battery
- Wireless card
- Camera assembly
- Bottom cover
- Power-supply unit
- Power-supply fan
- Heat sink
- Processor
- Rear-I/O bracket
- System board
- Speakers
- Power-button board
- Microphones
- Side I/O-board
- Audio board
- Antenna modules
- Display panel
- Middle frame
- Drivers and downloads
- BIOS setup
- Troubleshooting
- Getting help and contacting Dell
Steps
1. Align the notch on the memory module with the tab on the memory-module slot.
2. Slide the memory module firmly into the slot at an angle and press the memory module down until it clicks into place.
NOTE: If you do not hear the click, remove the memory module and reinstall it.
NOTE: Repeat step 1 and 2 if there are two memory modules.
3. Align the tabs on the DIMM door with the slots on the system-board shield and snap into place.
Next steps
1. Install the back cover.
2. Install the cable cover (optional).
3. Install the stand.
4. Follow the procedure in After working inside your computer.
Removing and installing components
27