Service Manual
Table Of Contents
- OptiPlex 5400 Service Manual
- Contents
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of OptiPlex 5400 All-in-One
- Stand
- Cable cover—optional
- Back cover
- Hard drive
- Memory modules
- System-board shield
- Solid-state drive
- Removing the M.2 2230 solid-state drive-slot 1
- Installing the M.2 2230 solid-state drive-slot 1
- Removing the M.2 2280 solid-state drive-slot 1
- Installing the M.2 2280 solid-state drive-slot 1
- Removing the M.2 2230 solid-state drive-slot 2
- Installing the M.2 2230 solid-state drive-slot 2
- Removing the M.2 2280 solid-state drive-slot 2
- Installing the M.2 2280 solid-state drive-slot 2
- System fan
- Coin-cell battery
- Wireless card
- Camera assembly
- Bottom cover
- Power-supply unit
- Power-supply fan
- Heat sink
- Processor
- Rear-I/O bracket
- System board
- Speakers
- Power-button board
- Microphones
- Side I/O-board
- Audio board
- Antenna modules
- Display panel
- Middle frame
- Drivers and downloads
- BIOS setup
- Troubleshooting
- Getting help and contacting Dell
About this task
The following image indicates the location of the processor and provides a visual representation of the removal procedure.
Steps
1. Press the release lever down and then push it away from the processor to release it from the securing tab.
2. Extend the release lever completely, and open the processor cover.
CAUTION:
When removing the processor, do not touch any of the pins inside the socket or allow any objects
to fall on the pins in the socket.
3. Gently lift the processor from the processor socket.
Installing the processor
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the processor and provides a visual representation of the installation procedure.
Removing and installing components
61