User Manual
Table Of Contents
- OptiPlex 5400 Service Manual
- Contents
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of OptiPlex 5400 All-in-One
- Stand
- Cable cover—optional
- Back cover
- Hard drive
- Memory modules
- System-board shield
- Solid-state drive
- Removing the M.2 2230 solid-state drive-slot 1
- Installing the M.2 2230 solid-state drive-slot 1
- Removing the M.2 2280 solid-state drive-slot 1
- Installing the M.2 2280 solid-state drive-slot 1
- Removing the M.2 2230 solid-state drive-slot 2
- Installing the M.2 2230 solid-state drive-slot 2
- Removing the M.2 2280 solid-state drive-slot 2
- Installing the M.2 2280 solid-state drive-slot 2
- System fan
- Coin-cell battery
- Wireless card
- Camera assembly
- Bottom cover
- Power-supply unit
- Power-supply fan
- Heat sink
- Processor
- Rear-I/O bracket
- System board
- Speakers
- Power-button board
- Microphones
- Side I/O-board
- Audio board
- Antenna modules
- Display panel
- Middle frame
- Drivers and downloads
- BIOS setup
- Troubleshooting
- Getting help and contacting Dell
3. Install the cable cover (optional).
4. Install the stand.
5. Follow the procedure in After working inside your computer.
Camera assembly
Removing the camera assembly
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the stand.
3. Remove the cable cover (optional).
4. Remove the back cover.
5. Remove the system-board shield.
About this task
The following image indicates the location of the camera assembly and provides a visual representation of the removal
procedure.
46 Removing and installing components