User Manual
Table Of Contents
- OptiPlex 5400 Service Manual
- Contents
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of OptiPlex 5400 All-in-One
- Stand
- Cable cover—optional
- Back cover
- Hard drive
- Memory modules
- System-board shield
- Solid-state drive
- Removing the M.2 2230 solid-state drive-slot 1
- Installing the M.2 2230 solid-state drive-slot 1
- Removing the M.2 2280 solid-state drive-slot 1
- Installing the M.2 2280 solid-state drive-slot 1
- Removing the M.2 2230 solid-state drive-slot 2
- Installing the M.2 2230 solid-state drive-slot 2
- Removing the M.2 2280 solid-state drive-slot 2
- Installing the M.2 2280 solid-state drive-slot 2
- System fan
- Coin-cell battery
- Wireless card
- Camera assembly
- Bottom cover
- Power-supply unit
- Power-supply fan
- Heat sink
- Processor
- Rear-I/O bracket
- System board
- Speakers
- Power-button board
- Microphones
- Side I/O-board
- Audio board
- Antenna modules
- Display panel
- Middle frame
- Drivers and downloads
- BIOS setup
- Troubleshooting
- Getting help and contacting Dell
Steps
1. Remove the 17 screws (M3x5) that secure the middle frame to the display-assembly base.
2. Remove the middle frame and lift the middle frame off the display-assembly base.
Installing the middle frame
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the middle frame and provides a visual representation of the middle frame
installation procedure.
88
Removing and installing components