Dell Remote Access Controller Tool (DRACT) and Active Directory Setup Package (ADSP) Version 1.
Dell Remote Access Configuration Tool (DRACT) discovers and configures the Remote Access Controllers (RACs) for systems on your network from a single console. The Active Directory Setup Package (ADSP) is a self-extracting package that contains the required Dell-specific tools to configure an Active Directory server and RACs to enable AD authentication to RACs.
7. 8. 9. Click Next. The Confirm Installation window is displayed. Click Next to start the installation. After the installation is complete, the Installation Complete window is displayed. Click Close to exit the application. Installing DRACT Using Command Line Interface (CLI) To install DRACT using CLI, run the following command at the command prompt: msiexec /I /.msi Where, is the location of the DRACT installer file and is the DRACT installer name.
Uninstalling DRACT Using Control Panel To uninstall DRACT using the Control Panel, go to Start > Control Panel > Add or Remove Programs, select Dell Remote Access Configuration Tool, and click Remove. After DRACT is uninstalled, it is removed from the list. Uninstalling DRACT Using CLI To uninstall DRACT using CLI, run the following command at the command prompt: msiexec /x /.msi where, is the location of the DRACT installer file and is the DRACT installer name.
Global Support For information on technical support, visit www.dell.com/contactus. For information on documentation support, visit support.dell.com/manuals. On the Manuals page, click Software ‐>Systems Management. Click on the specific product on the right‐side to access the documents. Information in this document is subject to change without notice. © 2012 Dell Inc. All rights reserved. Reproduction of these materials in any manner whatsoever without the written permission of Dell Inc.