User Manual

Table Of Contents
Installing the heat sink
NOTE: This procedure is only for the UMA model.
1. Place the heat sink on the system board.
2. Replace the four (M2x3) screws that secure the heat sink on the system board.
NOTE:
Replace the heat sink screws in sequential order as indicated on the heat-sink.
3. Install the :
a. battery
b. base cover
4. Follow the procedure in After working inside your computer.
System fan
Removing the system fan
NOTE: This procedure is only for the UMA model
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. base cover
b. battery
c. hard drive
d. SSD card
e. SSD frame
f. WLAN card
28
Removing and installing components