Specifications

Installing the Software 19
The S25N, S25V, and S25P systems do not have a dedicated management port,
nor a separate management routing able. Configure any port on one of the
chassis to be the port through which you manage the system and configure an IP
route to that gateway.
Configure the Management Port IP Address
Assign IP addresses to the management ports in order to access the system
remotely.
NOTE: Assign different IP addresses to each RPM’s management port.
Configure a Management Route
Define a path from the system to the network from which you are accessing the
system remotely. Management routes are separate from IP routes and are only
used to manage the system through the management port.
Step Task Command Syntax Command Mode
1 Configure an IP address for the
port through which you will
manage the system.
ip address INTERFACE
2 Configure an IP route with a
default gateway.
ip route CONFIGURATION
3 Configure a username and
password.
username CONFIGURATION
Step Task Command Syntax Command Mode
1 Enter INTERFACE
mode for the
Management port.
interface ManagementEthernet
slot/port
CONFIGURATION
2 Assign an IP address
to the interface.
ip address ip-address/mask INTERFACE
3 Enable the interface. no shutdown INTERFACE