User Manual

32 | Operating the Monitor
Display
Use Display to adjust image.
Response
Time
Allows you to set the Response Time to Normal or Fast.
ULMB
ULMB (Ultra Low Motion Blur) helps have less of a motion blur effect
while you are watching fast-moving images. When the graphics card
supports G-SYNC, make sure that the Enable G-SYNC function is not
selected in the NVIDIA Control Panel, ULMB will be automatically
enabled.
NOTE: This function is available when the refresh rate is 85 Hz, 100 Hz
or 120 Hz.
NOTE: When ULMB is enabled, the message of ULMB Mode is
displayed on the lower-left corner of the OSD. When G-SYNC is
enabled in the NVIDIA Control Panel, the message of G-SYNC Mode is
displayed instead. If your system doesn’t support G-SYNC, then the
message of Normal Mode is displayed.
ULMB Pulse
Width
Allows you to adjust the panel's backlight a bit, so as to reduce motion
blur. Use
or to adjust the level from 10 to 100. Smaller values
decrease motion blur and brightness.
Reset Display
Select this option to restore default display settings.