Installation Guide

4. Disassembly and Assembly Procedures
Take a stand close to the monitor. Fit the two tabs on
the upper part of the stand into the grooves on the
back of the monitor, and then lower the stand so that
the monitor mounting area snaps onto the stand.
Lift up the monitor to checking the gap between the
front bezel with panel module , then provide power
supply and a video signal to the monitor
, then turn on
the monitor for functionality check.
Use a Philips-head screwdriver to tighten 4pcs
screws for locking the rear cover with the assembled
unit. Paste 2pcs labels on the specific positions.
(No.1~4 screw size=M4x10; Torque=9±0.5kgfxcm)
S21
S20
2
3
4
1
Take 1pcs base, assemble the base with the stand,
then use a screwdriver to tighten the detached screw
clockwise for locking the stand with base.
S22
S23