Users Guide
Table Of Contents
- Safety instructions
- About your monitor
- Setting up the monitor
- Connecting the stand
- Using the tilt, swivel, and vertical extension
- Rotating the display
- Configuring the display settings on your computer after rotation
- Operating the monitor webcam
- Connecting your monitor
- Organizing your cables
- Securing your monitor using Kensington lock (optional)
- Removing the monitor stand
- Wall mounting (optional)
- Operating the monitor
- Troubleshooting
- Appendix
28 | Setting up the monitor
Setting up the monitor
Connecting the stand
NOTE: The stand riser and stand base are detached when the monitor is
shipped from the factory.
NOTE: The following instructions are applicable only for the stand that
is shipped with your monitor. If you are connecting a stand that you
purchased from any other source, follow the setup instructions that were
included with the stand.
To attach the monitor stand:
1. Align and place the stand riser on the stand base.
2. Open the screw handle at the bottom of the stand base and turn it clockwise to
secure the stand assembly.
3. Close the screw handle.