Installation guide

S60 Quick Start Guide 7
Install the SFP and SFP+ optics
The S60 has 4 SFP optical ports in the front of the chassis in addition to the optional SFP+ optical modules.
To install SFP or SFP+ optics into an open port, follow the steps below:
6 Remove the module from its packaging and slide the module into the slot.
7 Secure the captive screw on the side of the module.
Attention: Electrostatic discharge (ESD) damage can occur if components are mishandled. Always wear
an ESD-preventive wrist or heel ground strap when handling the S60 and its components.
Step Task
1 Position the SFP or SFP+ so it is in the upright position. (The optic has a key that prevents it from
being inserted incorrectly.)
2 Insert the optic into the port until it gently snaps into place.
Step Task