Installation guide

8 Hardware Installation
Supply power and power up the system
Supply power to the S60 after they are mounted in a rack (or on a table) and the optional modules are
installed.
AC power
Connect the plug to each AC receptacle, making sure that the power cord is secure. As soon as the cable is
connected between the S60 and the power source, the chassis is powered-up; there is no on/off switch.
DC power
Connect the cable to the DC receptacle at the rear of the S60, making sure that the power cord is secure.
When the cable is secured, turn the power switch on.
Note: For details on Force10 Networks’ supported optics, refer to http://www.force10networks.com/
products/specifications.asp
Note: A US AC power cable is included in the shipping container for powering up an AC power supply. All
other power cables must be ordered separately
Attention: Electrostatic discharge (ESD) damage can occur if components are mishandled. Always wear
an ESD-preventive wrist or heel ground strap when handling the S60 and its components.