Installation guide

20 Getting Started
View Files
File information and content can only be viewed on local file systems.
To view a list of files on the internal or external Flash:
The output of the command
dir also shows the read/write privileges, size (in bytes), and date of
modification for each file, as shown in Figure 8.
Task Command Syntax Command Mode
Save the running-configuration to:
EXEC Privilege
the startup-configuration on the
internal flash of the primary
RPM
copy running-config startup-config
the internal flash on an RPM copy running-config rpm{0|1}flash://filename
Note: The internal flash memories on the RPMs are synchronized whenever there
is a change, but only if the RPMs are running the same version of FTOS.
the external flash of an RPM
copy running-config rpm{0|1}slot0://filename
an FTP server
copy running-config ftp://
username:password
@{hostip | hostname}/
filepath/filename
a TFTP server copy running-config tftp://{hostip | hostname}/
filepath/filename
an SCP server copy running-config scp://{hostip | hostname}/
filepath/filename
Note: When copying to a server, a hostname can only be used if a DNS server is configured.
Save the running-configuration to the
startup-configuration on the internal
flash of the primary RPM. Then copy
the new startup-config file to the
external flash of the primary RPM.
copy running-config startup-config duplicate
EXEC Privilege
Step Task Command Syntax Command Mode
1 View a list of files on:
EXEC Privilegethe internal flash of an RPM
dir flash:
the external flash of an RPM
dir slot: