Manualshelf

Installation guide

ManualsBrandsDell ManualsNetworkingS60
19202122232425262728
22 Getting Started
Figure 9 Tracking Changes with Configuration Comments
File System Management
The Force10 system can use the internal Flash, external Flash, or remote devices to store files. It stores
files on the internal Flash by default but can be configured to store files elsewhere.
To view file system information:
The output of the command
show file-systems (Figure 10) shows the total capacity, amount of free
memory, file structure, media type, read/write privileges for each storage device in use.
Figure 10 show file-systems Command Example
You can change the default file system so that file management commands apply to a particular device or
memory.
To change the default storage location:
In Figure 11, the default storage location is changed to the external Flash of the primary RPM. File
management commands then apply to the external Flash rather than the internal Flash.
Task Command Syntax Command Mode
View information about each file system.
show file-systems
EXEC Privilege
Task Command Syntax Command Mode
Change the default directory.
cd directory
EXEC Privilege
Force10#show running-config
Current Configuration ...
! Version 8.2.1.0
! Last configuration change at Thu Apr 3 23:06:28 2008 by admin
! Startup-config last updated at Thu Apr 3 23:06:55 2008 by admin
!
boot system rpm0 primary flash://FTOS-EF-8.2.1.0.bin
boot system rpm0 secondary flash://FTOS-EF-7.8.1.0.bin
boot system rpm0 default flash://FTOS-EF-7.7.1.1.bin
boot system rpm1 primary flash://FTOS-EF-7.8.1.0.bin
boot system gateway 10.10.10.100
--More--