Installation guide

S60 Quick Start Guide 1
This document is intended to aid you with quick installation and set-up of a new S60 system.
• For complete S60 installation information, including illustrations and display details, refer to Installing
the S60 System (included in the shipping box with the new chassis).
• For complete information regarding the configuration of the S60 and FTOS features, refer to the FTOS
Configuration Guide for the S60 and the FTOS Command Line Reference Guide for the S60.
Introduction
The Force10 Networks S60 is a high performance, high capacity, low cost, stackable, Layer 2 switch/Layer
3 router that supports 44 built-in 10/100/1000 Base-T ports, four SFP (small form-factor pluggable) ports,
and an optional SFP+ module. The front of the S60 contains the Power Supply Units (PSUs), optional
module slots and the grounding connectors. As shown in the rear panel of the S60 contains the 44 ethernet
ports, optional module ports, the management ports and the displays for alarms and stacking identification.
Equipment
To successfully install the S60, ensure that you have the following:
• S60 chassis
• At least one grounded AC or DC power source per chassis
• Cable to connect the AC or DC power source to the chassis (US AC power cable included)
• Mounting brackets for rack installation (included)
• Screws for rack installation and #1#2 Phillips screwdrivers (not supplied)
• Ground cable (not supplied)
• Ground cable screws (included)
• copper/fiber cables
Other optional components are:
• Additional Power Supply Unit
• Additional Fan module
• Optional modules (if using)
Chapter 1 S60 Overview