User's Manual

Option Description
• Disabled—Default
• Every Day
• Weekdays
• Select Days
Deep Sleep Control
Allows you to define the controls when Deep Sleep is enabled.
Click one of the options:
• Disabled—Default
• Enabled in S5 only
• Enabled in S4 and S5
Fan Speed Control
Allows you to control the speed of the system fan.
Click one of the options:
• Low
• Auto—Default
NOTE: Low = Fans run low and quite. System performance may decrease.
Auto = Fans run at optimal speed based on environmental data. System performance is
maximized.
USB Wake Support
Allows you to enable USB devices to wake the system from standby.
• Enable USB Wake Support
This option is set by default.
Wake on LAN
This option allows the computer to power up from the off state when triggered by a special LAN signal.
Wake-up from the Standby state is unaffected by this setting and must be enabled in the operating
system. This feature only works when the computer is connected to AC power supply.
• Disabled - Does not allow the system to power on by special LAN signals when it receives a wake-up
signal from the LAN or wireless LAN.
• LAN Only - Allows the system to be powered on by special LAN signals.
• LAN with PXE Boot - Allows the system to power on and immediately boot to PXE when it receives
a wake-up packet sent to the system in either the S4 or S5 state.
All the options are not set by default.
Block Sleep Allows you to block entering to sleep(S3 state) in OS Environment.
This option is not set by default.
Post behaviour
Table 12. POST Behavior
Option Description
Numlock LED
Specifies if the NumLock function can be enabled when the system boots. This option is set by default.
Keyboard Errors
Specifies whether keyboard related errors are reported when it boots. This option is set by default.
Extend BIOS POST Time
Allows you to create additional pre-boot delay and see POST status messages.
Click one of the following options:
• 0 seconds(Default)
• 5 seconds
• 10 seconds
98 System Setup