Users Guide
Table Of Contents
- Operating the Monitor
- Operating your monitor
- About your monitor
- Setting up the monitor
- Operating your monitor
- OSD warning messages
- Troubleshooting
- Self-test
- Built-in diagnostics
- Common problems
- Product-specific problems
- Monitor specifications
- Flat panel specifications
- Resolution specifications
- Supported video modes
- FreeSync Graphic Card Support List
- Preset display modes
- Electrical specifications
- Physical characteristics
- Environmental characteristics
- Pin assignments
- Appendix
Operating your monitor | 19
Auto
Use this key to activate automatic setup and adjust menu.
Dell 24 Monitor
Brightness / Contrast
Auto Adjust
Input Source
Color
Display
Menu
Personalize
Others
Press to adjust the screen automatically.
The following dialog appears on a black screen as the monitor
self-adjusts to the current input:
Auto Adjustment in Progress...
Auto adjustment allows the monitor to self-adjust to the
incoming video signal. After using auto adjustment, you can
further tune your monitor by using the pixel clock (coarse) and
phase (ne) controls under display settings.
NOTE: Auto adjust does not occur if you press the button
while there are no active video input signals or attached cables.
This option is only available when you are using the analog
(VGA) connector.