Users Guide
Table Of Contents
- Operating the Monitor
- Operating your monitor
- About your monitor
- Setting up the monitor
- Operating your monitor
- OSD warning messages
- Troubleshooting
- Self-test
- Built-in diagnostics
- Common problems
- Product-specific problems
- Monitor specifications
- Flat panel specifications
- Resolution specifications
- Supported video modes
- FreeSync Graphic Card Support List
- Preset display modes
- Electrical specifications
- Physical characteristics
- Environmental characteristics
- Pin assignments
- Appendix
Troubleshooting | 33
Troubleshooting
WARNING: Before you begin any of the procedures in this section, follow the Safety
instructions.
Self-test
Your monitor provides a self-test feature that allows you to check if your monitor is
functioning properly. If your monitor and computer are properly connected but the monitor
screen remains dark, run the monitor self-test by performing the following steps:
1.
Turn off both your computer and the monitor.
2.
Disconnect all video cables from the monitor. This way, the computer doesn’t have to
be involved.
3.
Turn on the monitor.
If the monitor is working correctly, it detects that there is no signal and one of the following
message appears. While in self-test mode, the power LED remains white.
No VGA Cable
The display will go into Standby Mode in 4 minutes.
www.dell.com/SE2417HGX
?
Dell 24 Monitor
SE2417HGX
No HDMI 1 Cable
The display will go into Standby Mode in 4 minutes.
www.dell.com/SE2417HGX
?
Dell 24 Monitor
SE2417HGX