Users Guide

ManualsBrandsDell ManualsAlienware and Dell Gaming MonitorsSE2422HX

ELL

2422HX

1. Disassembly Procedures

Turn off the monitor.

To remove the stand:

Place a flat cushion or a sitting mat near

the edge of a table and place the

monitor on it with the display facing

down.

Press the stand down to access to the

Stand release button.

Use a long screwdriver to press the

release latch.

While pressing the release latch, slide

out the stand assembly from the monitor

To remove the VESA cover

Press the dimple on the VESA cover to

release it from the back of the display

Unlock 4 RC screws

(Screw Torque: 8.5±1.0kgf)

Unlock 2 Bracket screws

(Screw Torque: 5.0±1.0kgf)

Summary of content (6 pages)

PAGE 1
DELL SE2422HXB 1 1. Disassembly Procedures S1 S2 Turn off the monitor. S4 Unlock 4 RC screws To remove the stand: Place a flat cushion or a sitting mat near the edge of a table and place the monitor on it with the display facing down. Press the stand down to access to the Stand release button. (Screw Torque: 8.5±1.0kgf) Use a long screwdriver to press the release latch.
PAGE 2
DELL SE2422HXB S6 Disassemble Rear Cover from Bezel S8 2 Remove 1 tape from Backlight Wire Notice the disassembly order: 1) Disassemble the Top part 2) Disassemble the Left / Right part 3) Disassemble the Bottom part 4) Remove Rear Cover from Bezel S7 Disassemble CTRL BD FFC from I/F BD and tear off CTRL BD FFC from Main SHD and Panel Disassemble LVDS cable from panel S9 Disassemble Backlight Wire from panel and SPS BD S10 Remove 2 tapes from Main SHD to take off Main SHD from Panel
PAGE 3
DELL SE2422HXB S11 3 Disassemble Bezel from panel S14 Unlock 2 hex screws (Screw Torque: 5.0±0.6kgf) S15 S12 Unlock 5 PCBA screws Disassemble CTRL BD from Bezel (Screw Torque: 8.5±1.
PAGE 4
DELL SE2422HXB S17 Remove electrolyte capacitors (red mark) from printed circuit boards S17-1 Cut the glue between bulk cap. and PCB with a knife S17-2 Ensure cutting path within the glue, don’t touch bulk cap.
PAGE 5
DELL SE2422HXB 5 S17-3 Take out bulk cap. pin solder with soldering iron and absorber S18-4 Lift the bulk cap.
PAGE 6
DELL SE2422HXB 2. Product material information The following substances, preparations, or components should be disposed of or recovered separately from other WEEE in compliance with Article 4 of EU Council Directive 75/442/EEC.