Setup Guide
Table Of Contents
- 1 Introduction
- 2 iDRAC9 Configuration for RSA SecurID
- 3 RSA SecurID 2FA with Local Users
- 4 RSA SecurID 2FA with Active Directory Users
- 5 RSA SecurID 2FA with Generic LDAP Directory Users
- 6 Troubleshooting RSA SecurID Issues
- 6.1 Misconfiguration or iDRAC Configuration Gets Reset
- 6.2 Datacenter License Expires or Gets Downgraded or Deleted
- 6.3 Authentication Failures without being Prompted for RSA Passcode
- 6.4 Authentication failures with Correct RSA Passcode
- 6.5 Authentication Failures with Correct RSA Passcode due to Timeout
- 6.6 RSA Configuration gets lost after importing Server Configuration Profile
- Appendix A: Configure iDRAC Using RACADM
- Appendix B: References
RSA SecurID 2FA with Local Users
ID 450
3 RSA SecurID 2FA with Local Users
3.1 Enable RSA SecurID 2FA on an iDRAC Local User
iDRAC administrator can enable RSA SecurID 2FA on some local users. To do so, follow iDRAC UI
navigation menu iDRAC Settings -> Users -> Local Users. Select an existing user and click Edit, the Edit
User page will be displayed. At the bottom of the user configuration page, find RSA SecurID section. See
image below.
Now you can enable or disable RSA SecurID. Click the link RSA SecurID Configuration to view or edit RSA
SecurID global settings.
RSA SecurID enablement on a local user
Notes:
1. To make RSA SecurID 2FA work on a local user, the same name user ID must be present or created in
RSA AM local user database.
2. iDRAC gives administrators flexibility to turn on either Easy 2FA, or RSA 2FA, or even both for a specified
user.