Setup Guide
Table Of Contents
- 1 Introduction
- 2 iDRAC9 Configuration for RSA SecurID
- 3 RSA SecurID 2FA with Local Users
- 4 RSA SecurID 2FA with Active Directory Users
- 5 RSA SecurID 2FA with Generic LDAP Directory Users
- 6 Troubleshooting RSA SecurID Issues
- 6.1 Misconfiguration or iDRAC Configuration Gets Reset
- 6.2 Datacenter License Expires or Gets Downgraded or Deleted
- 6.3 Authentication Failures without being Prompted for RSA Passcode
- 6.4 Authentication failures with Correct RSA Passcode
- 6.5 Authentication Failures with Correct RSA Passcode due to Timeout
- 6.6 RSA Configuration gets lost after importing Server Configuration Profile
- Appendix A: Configure iDRAC Using RACADM
- Appendix B: References
RSA SecurID 2FA with Generic LDAP Directory Users
ID 450
5 RSA SecurID 2FA with Generic LDAP Directory Users
5.1 Enable RSA SecurID 2FA on Generic LDAP Directory Users
Similarly, RSA SecurID 2FA is applied to all or none of LDAP users.
To enable or disable RSA SecurID 2FA on LDAP users, go to iDRAC UI, follow the navigation menu from
iDRAC Settings -> Users -> Directory Services. From there, select Generic LDAP Directory Service and
click Edit button. On the second LDAP service configuration page, locate the RSA SecurID State dropdown
box to enable or disable RSA SecurID 2FA on LDAP users.
See Figure 4.
RSA SecurID enablement on generic LDAP directory users
5.2 Log in to iDRAC from UI with an LDAP User Account
Another option is to use an LDAP user adm_fwoldap to perform UI login.