White Papers

(A) Viewing network settings
10 MX7000 Deployment of Management Module Network using the LCD control panel | Document
ID
To change the IPv4 configuration to DHCP, start from the Main menu described in the “Start IPv4 network
changes” section.’
Configure IPv4 setting to DHCP
Press the IPv4 button (Figure-6 item 1), then press the DHCP button (Figure-6 item 2) and you will be asked
to confirm (Figure-6 item 3) that you intend to change the IPv4 setting to DHCP. Pressing “Yes” in the
confirmation page initiates the DHCP configuration process.
For a short period of time, you may see the Save in-progress icon (Figure-6 item 4). When the configuration
process is complete, you will see the “Success” menu (Figure-6 item 5). Press “Close” button to conclude the
configuration.
NOTE: Although the configuration has concluded, the information in the LCD may take a few seconds to
reflect the changes.
B.4 (D) Disabling IPv4 network
To disable the IPv4 network, start from the Main menu described in the “Start IPv4 network changes” section.