Release Notes

15 Dell PowerEdge VRTX Networking | Version 1.6
16. Click Apply.
17. Click the floppy drive icon in the upper-right corner of the Port Settings: Edit page to
save all new settings to the start-up configuration.
2.4 Configuring Trunk Ports
Note: The following information applies to the 1GbE switch module. The steps to configure
the 10GbE switch module are similar (only the port numbering changes).
1. Expand Port Settings in the VRTX Switch Module Home page’s left pane. See
Figure 14.
2. Click Edit on the Port Settings tab.
3. Select the External Port radio button.
4. Select gi0/1 on the drop-down menu, which is the external port connected to the
uplink switch. All the VLANs must be in the VLAN list field.
5. Select Trunk from the Port VLAN Mode drop-down menu.
6. Enter 10 in the VLAN List field, and click Add.
7. Click Apply.
8. Enter 20 in the VLAN List field and click Apply.
9. Click the floppy drive icon in the upper-right of the Port Settings : Edit page to save all
the new settings to start-up configuration.
Assigning Trunk Ports
Note: Figure 14 is only an example and not representative of the previous settings made.