Deployment Guide
Table Of Contents
- VXLAN and BGP EVPN Configuration Guide for Dell EMC SmartFabric OS10 Release 10.5.2
- VXLAN
- VXLAN concepts
- VXLAN as NVO solution
- Configure VXLAN
- L3 VXLAN route scaling
- DHCP relay on VTEPs
- View VXLAN configuration
- VXLAN MAC addresses
- Example: VXLAN with static VTEP
- Controller-provisioned VXLAN
- BGP EVPN for VXLAN
- BGP EVPN compared to static VXLAN
- VXLAN BGP EVPN operation
- Configure BGP EVPN for VXLAN
- BGP EVPN with VLT
- VXLAN BGP EVPN routing
- Example: VXLAN with BGP EVPN
- Example: VXLAN BGP EVPN — Multiple AS topology
- Example: VXLAN BGP EVPN — Centralized L3 gateway
- Example: VXLAN BGP EVPN — Border leaf gateway with asymmetric IRB
- Example: VXLAN BGP EVPN—Symmetric IRB
- Example - VXLAN BGP EVPN symmetric IRB with unnumbered BGP peering
- Example - Route leaking across VRFs in a VXLAN BGP EVPN symmetric IRB topology
- Example: Migrating from Asymmetric IRB to Symmetric IRB
- VXLAN MAC commands
- clear mac address-table dynamic nve remote-vtep
- clear mac address-table dynamic virtual-network
- show mac address-table count extended
- show mac address-table count nve
- show mac address-table count virtual-network
- show mac address-table extended
- show mac address-table nve
- show mac address-table virtual-network
- VXLAN BGP commands
- VXLAN commands
- hardware overlay-routing-profile
- interface virtual-network
- ip virtual-router address
- ip virtual-router mac-address
- member-interface
- nve
- remote-vtep
- show hardware overlay-routing-profile mode
- show interface virtual-network
- show nve remote-vtep
- show nve remote-vtep counters
- show nve vxlan-vni
- show virtual-network
- show virtual-network counters
- show virtual-network interface counters
- show virtual-network interface
- show virtual-network vlan
- show vlan (virtual network)
- source-interface loopback
- virtual-network
- virtual-network untagged-vlan
- vxlan-vni
- VXLAN EVPN commands
- Support resources
- Index
b. Enable auto-EVI creation for overlay virtual networks in EVPN mode. Auto-EVI creation is supported only if BGP
EVPN is used with 2-byte AS numbers and if at least one BGP instance is enabled with the EVPN address family. No
further manual configuration is allowed in auto-EVI mode.
auto-evi
● Manual EVI configuration mode
a. Enable the EVPN control plane in CONFIGURATION mode.
evpn
b. Manually create an EVPN instance in EVPN mode. The range is from 1 to 65535.
evi id
c. Configure the Route Distinguisher in EVPN EVI mode.
rd {A.B.C.D:[1-65535] | auto}
Where:
○ rd A.B.C.D:[1-65535] configures the RD with a 4-octet IPv4 address then a 2-octet-number.
○ rd auto automatically generates the RD.
d. Configure the RT values in EVPN EVI mode.
route-target {auto | value [asn4] {import | export | both}}
Where:
○ route-target auto auto-configures an import and export value for EVPN routes.
○ route-target value [asn4]{import | export | both} configures an import or export value for
EVPN routes in the format 2-octet-ASN:4-octet-number or 4-octet-ASN:2-octet-number.
■ The 2-octet ASN number is 1 to 65535.
■ The 4-octet ASN number is 1 to 4294967295.
To configure the same value for the RT import and export values, use the both option. asn4 advertises a 2-byte
AS number as a 4-byte route target value. If you specify the asn4 option, configure the VXLAN network ID
associated with the EVPN instance in EVPN EVI mode, from 1 to 16,777,215. Configure the same VNI value that
you configure for the VXLAN virtual network. For more information, see Configure VXLAN.
vni vni
3. Verify the BGP EVPN configuration.
Display the EVPN instance configuration
OS10# show evpn evi 1
EVI : 65447, State : up
Bridge-Domain : (Virtual-Network)100, (VNI)100
Route-Distinguisher : 1:110.111.170.102:65447(auto)
Route-Targets : 0:101:268435556(auto) both
Inclusive Multicast : 110.111.170.107
Display the VXLAN overlay for the EVPN instance
OS10# show evpn vxlan-vni
VXLAN-VNI EVI Virtual-Network-Instance
100001 1 1
100010 2 2
Display the BGP neighbors in the EVPN instances
OS10# show ip bgp neighbors 110.111.170.102
BGP neighbor is 110.111.170.102, remote AS 100, local AS 100 internal link
BGP version 4, remote router ID 110.111.170.102
BGP state ESTABLISHED, in this state for 04:02:59
Last read 00:21:21 seconds
Hold time is 180, keepalive interval is 60 seconds
Configured hold time is 180, keepalive interval is 60 seconds
Fall-over disabled
VXLAN
55










