Owner's Manual

11
OpenFlow Commands
Use the following commands for software-defined networking (SDN) OpenFlow.
• connect retry-interval
• controller
• debug openflow packets
• fail-mode secure
• flow-map
• flow-misses drop
• interface-type
• interface vlan
• multiple-fwd-table
• of-instance (Interface)
• of-instance (Configuration)
• openflow vlan
• show openflow
• show openflow flows
• shutdown
• src-suppression
SDN Command Modes
To navigate and launch various CLI modes, use the following commands.
CONFIGURATION Mode
In EXEC Privilege mode, use the configure command to enter CONFIGURATION mode and configure
routing protocols and access interfaces.
To enter CONFIGURATION mode:
1. Verify that you are logged in to EXEC Privilege mode.
2. Enter the configure command. The prompt changes to include (conf).
From this mode, you can enter INTERFACE mode by using the interface command.
EXEC Mode
When you initially log in to the switch, by default, you are logged in to EXEC mode. This mode allows you
to view settings and enter EXEC Privilege mode, which is used to configure the device.
When you are in EXEC mode, the > prompt is displayed following the host name prompt, which is “Dell”
by default. You can change the host name prompt using the hostname command.
33