Owner's Manual

Command

History

Version 9.3(0.0) Introduced on the S6000.

Version 9.2(0.0) Introduced on the S4820T and MXL.

Version 9.1(0.0) Introduced on the Z9000 and S4810.

Usage

Information

This is a vendor-specific CLI.

Commands

openflow of-instance — Creates or modifies an OpenFlow instance.

of-instance (Interface)

Add a physical interface or LAG to an OpenFlow instance. After you assign an interface to an OF instance,

you cannot apply L2 or L3 protocols to that instance.

Z9000, S4810, S4820T, S6000, and MXL

Syntax

of-instance of-id

Parameter

of-id Enter the OpenFlow instance ID. The range is from 1 to 16.

Command

Modes

INTERFACE MODE

Command

History

Version 9.3(0.0) Introduced on the S6000.

Version 9.2(0.0) Introduced on the S4820T and MXL.

Version 9.1(0.0) Introduced on the Z9000 and S4810.

Example In the following example, the ports Te 0/7 and Te 0/31 are associated with of-

instance 1:

Dell(conf)#interface tengigabitethernet 0/7

Dell(conf-if-te-0/7)#of-instance 1

Dell(conf-if-te-0/7)#interface tengigabitethernet 0/31

Dell(conf-if-te-0/31)#of-instance 1

Dell(conf-if-te-0/31)#

Usage

Information

To enable OpenFlow, associate a port or a VLAN to an OF instance. Associate ports

and VLANs when you create the OF instance and it is disabled using the shutdown

command.

Before applying the interface, the software checks to ensure that none of the

following apply:

• L2 or L3 more

• LACP is configured

• Included in a LAG

• Included in another OF instance