Owner's Manual

Command

History

Version 9.3(0.0) Introduced on the S6000.

Version 9.2(0.0) Introduced on the S4820T and MXL.

Version 9.1(0.0) Introduced on the Z9000 and S4810.

Usage

Information

To enable the OpenFlow instance, use the no shutdown command. When you

use the no shutdown command, the OpenFlow instance sends a request to the

OpenFlow controller to establish a connection.

To disable an OpenFlow instance, use the shutdown command. Use the

shutdown command before making any configuration changes to the OpenFlow

instance.

All OpenFlow instances are disabled by default.

Commands

openflow of-instance — Creates or modifies an OpenFlow instance.

controller — Configures the controller used by OpenFlow.

src-suppression

Prevents received packets from being sent out of the ingress port.

Z9000, S4810, S4820T, S6000, and MXL

Syntax

src-suppression

To allow received packets to be sent out of the ingress port, use the src-

suppression disable command.

Defaults none

Command

Modes

OPENFLOW INSTANCE

Command

History

Version 9.3(0.0) Introduced on the S6000.

Version 9.2(0.2) Introduced on the S4820T and MXL.

Version 9.2(0.2) Introduced on the Z9000 and S4810.

Usage

Information

Source suppression prevents received packets from being transmitted from the

ingress port. Source suppression is enabled by default and is applied to all instances

on the switch. If you disable source suppression, received packets can be

transmitted from the ingress port.