Install Guide
Table Of Contents
- About This Guide
- Storage Manager 2020 R1 Installation Guide
- Contents
- Introduction to Storage Manager
- Planning and Preparation
- Installing and Configuring the Data Collector
- Deploying and Configuring the Storage Manager Virtual Appliance
- Installing and Configuring the Storage Manager Client
- Connect to the Storage Manager Applications Page
- Install the Storage Manager Client on Windows
- Install the Storage Manager Client on Linux
- Use the Storage Manager Client to Connect to a Storage Center
- Use the Storage Manager Client to Connect to the Data Collector
- Add Storage Centers to Storage Manager
- Next Steps
- Updating Storage Manager Software
NOTE: The Storage Manager Virtual Appliance might take up to 15 minutes to update. The Unisphere Central login page
is displayed when the update is complete.
NOTE: When performing an update from Storage Manager Virtual Appliance 2016 R3 or earlier to Storage Manager
Virtual Appliance 2018 R1 or later, close the browser, wait up to 15 minutes, then reopen the browser and log in to the
Storage Manager Virtual Appliance.
Updating Storage Manager Software 31